MAGPUL SIGHT M4

Developed for military use and made from advanced, reinforced polymers, the GPS/Military Model is light enough to preserve weapon balance and deployment, yet still tough enough to withstand hard use, due to its hardened polymer covered stainless steel legs.This is an GPS weapon fore grip with a deployable bipod. When not in use the bipod rests in the body of the grip and is easily deployed with the push of a button. The bipod legs are polymer with metal reinforcements for durability.

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

Hogue rubber grips are molded from a durable synthetic rubber that is not spongy or tacky, but gives that soft recoil absorbing feel, without effecting accuracy. This modern rubber requires a completely different molding process than ordinary neoprene and results in a much superior grip. The material used does not come apart or deteriorate and is resistant to all solvents and oils used around firearms.

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle

Recoil buffers are an easy and inexpensive way to eliminate damage of critical components by preventing the metal to metal contact of the slide or breech block with the frame. Made from a high density polyurethane formulated for maximum shock-absorbing characteristics, the recoil buffer is a drop-in part.The CZ recoil buffer will eliminate the metal to metal impact of the slide on the receiver each time the weapon is fired. You will extend the service life of your pistol as well as have reduced felt recoil by installing one in your weapon. Installation is easy and requires no special tools or modification to your gun.

Lone Wolf stainless steel guide rods provide a decisive advantage for all Glock owners. Special features include a rigid stainless steel body that improves lock up by completely removing “guide rod flex”. The hex screw removable tip allows the user to choose various spring weights that will calibrate the ammunition to his gun. Used by Law Enforcement and competitive shooters world wide, will not chip or crack like the factory plastic guide rods are prone to do. Will not damage or wear your polymer frame and guaranteed to provide a lifetime of reliable service.

• The Hi-Lift 48 inch all-cast jack is constructed with cast iron components for ultimate strength and durability. Hi-Lift Jacks are the only all-cast jacks manufactured in the world.
• Top winch connector clamp and powder coated finish with zinc-plated hardware standard on all jacks
• Two piece handle and socket is durable and reliable
• Safe use information stickers, including rated load details and operating instructions, affixed to handle
• For greater safety, all Hi-Lift jacks are equipped with a shear bolt which prevents the jack from being used on loads greater than 7000 pounds

Beretta Large Bradley Front Sight. This sight is standard on Beretta 682 Gold E, DT10 Competition, ASE Gold, and A400 Xcel models. This sight will fit any Beretta shotgun except old blade style models. This sight will fit other shotguns that use a 2.6x.45 front sight.