GLOCK SIGHT Gl# 125 MODEL 17

• Fits Vortex Viper/Venom micro red dot sight
• Fits Ade Advanced Optics rd3-001, rd3-02, rd3-009, rd3-006a, fits Sightmark mini shot reflex sight
• Fits Burris Fastfire micro red dot sight(Notes: the screws included in the package are not long enough for some Burris red dot sights, you can use the screws in the red dot)
• Caution: NOT fit RMR, RMS, Doctor.

The PG-30 Grip Extension will fit (GEN 1-4) Glock models 30, 30SF, 30S. The Pearce Grip PG-30 Grip Extensions replace the magazine base plate and retains all other factory components. They do not alter the capacity of the magazine. The PG-30 will add additional length forming the next logical finger positioning for better control and comfort without sacrificing conceal ability. These units blend with the contours of the handgun giving a factory appearance.

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle

This item features: -Specially formulated paint in stick form designed to color-brighten stamped or engraved lines and lettering. -Paint stays flexible, expands and contracts with the surface. -Contains no solvents. -Long-lasting will not rub off or smear. -No mess or waste, eliminates dripping brushes and paint spills. -Temp. Range: -50.0 F [Min], 150.0 F [Max]. -Applicable Materials: Metal, Plastic, Ceramics, Wood, Rubber, Glass. Meets U.S.A. federal specification TT-F-325a I and MIL-STD 171.

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

Vibra-Tite 111 is a low strength, anaerobic thread locking compound. Vibra-Tite 111 is design for locking threaded fasteners that require disassembly with standard hand tools. The product performs on aluminum, steel, plated, stainless steel, and special alloy parts. Vibra-Tite 111 exhibits good temperature and solvent resistant.