HOGUE PISTOL GRIP P220

TALON Grips are textured, stick-on gun grips that help you get a secure hold on your firearm improving performance, safety, and confidence so you maintain control. Installation is quick and easy. The pistol grips will not move or shift once installed, however, they can be removed cleanly at any time, returning your pistol to original factory condition. You can expect 1 to 3 or more years of benefits from a TALON Grip.

Recoil buffers are an easy and inexpensive way to eliminate damage of critical components by preventing the metal to metal contact of the slide or breech block with the frame. Made from a high density polyurethane formulated for maximum shock-absorbing characteristics, the recoil buffer is a drop-in part.The CZ recoil buffer will eliminate the metal to metal impact of the slide on the receiver each time the weapon is fired. You will extend the service life of your pistol as well as have reduced felt recoil by installing one in your weapon. Installation is easy and requires no special tools or modification to your gun.

• Cartridge shell case size: Length is 6″. Width is 1″. Height is 4″.
• Close style ammo cartridge holder is made of quality waterproof nylon. Shooter`s pouch is equipped with 2 rows of elastic loops for 12 or 16 gauge shells and may accommodate up to 12 cartridges.
• This shotgun ammo wallet has two loops at the back to fix it on the belt. Accommodates belts up to 2 1/4 -Inch wide.
• Classic ammo holder for shotgun shells closes with snap buttons to keep your cartridges safe and dry.
• Belt ammo pouch is easy to clean and will keep rounds at hand.

Beretta Large Bradley Front Sight. This sight is standard on Beretta 682 Gold E, DT10 Competition, ASE Gold, and A400 Xcel models. This sight will fit any Beretta shotgun except old blade style models. This sight will fit other shotguns that use a 2.6x.45 front sight.

Blaser R8 Barrel key (5mm) for the barrel attachment screws the barrel on an R8 Rifle.

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.