GLOCK MEISTER G420 TRIGGER PIN

Hogue rubber grips are molded from a durable synthetic rubber that is not spongy or tacky, but gives that soft recoil absorbing feel, without effecting accuracy. This modern rubber requires a completely different molding process than ordinary neoprene and results in a much superior grip. The material used does not come apart or deteriorate and is resistant to all solvents and oils used around firearms.

Blaser sling swivel loop and pivot pin/screw.

Fits all Blaser rifles with fixed studs and will suit straps of up to 20mm x 3.5mm

If you want your shots to be on target at long ranges, you need to have your crosshairs leveled perfectly. Some alignment tools on the market level the crosshairs to the scope base or another arbitrary and inconsistent point. The Level-Level-Level scope crosshair alignment tool from Wheeler Engineering is a far better option.It works by aligning your scope with the top of the receiver, which is the most accurate point. The leveling can be done in minutes with this tool. You simply attach the first level to the receiver, place the other level on any flat point on top of the scope, and orient the scope so that the two levels match up! It fits most popular bolt action rifles, and it can be adjusted to fit more obscure designs.

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

The extended magazine release allows for a quick release of factory

magazines. Simply reach in front of the trigger guard and push forward,

no more having to push up on the factory release. It extends .550″ down

from the trigger guard housing designed not to interfere with benchrest

or sandbags during shooting. The extended magazine release is completely

CNC-machined from billet material – no castings.

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle