MAG RELEASE ORG# 287

The PG-30 Grip Extension will fit (GEN 1-4) Glock models 30, 30SF, 30S. The Pearce Grip PG-30 Grip Extensions replace the magazine base plate and retains all other factory components. They do not alter the capacity of the magazine. The PG-30 will add additional length forming the next logical finger positioning for better control and comfort without sacrificing conceal ability. These units blend with the contours of the handgun giving a factory appearance.

This item features: -Specially formulated paint in stick form designed to color-brighten stamped or engraved lines and lettering. -Paint stays flexible, expands and contracts with the surface. -Contains no solvents. -Long-lasting will not rub off or smear. -No mess or waste, eliminates dripping brushes and paint spills. -Temp. Range: -50.0 F [Min], 150.0 F [Max]. -Applicable Materials: Metal, Plastic, Ceramics, Wood, Rubber, Glass. Meets U.S.A. federal specification TT-F-325a I and MIL-STD 171.

Developed for military use and made from advanced, reinforced polymers, the GPS/Military Model is light enough to preserve weapon balance and deployment, yet still tough enough to withstand hard use, due to its hardened polymer covered stainless steel legs.This is an GPS weapon fore grip with a deployable bipod. When not in use the bipod rests in the body of the grip and is easily deployed with the push of a button. The bipod legs are polymer with metal reinforcements for durability.

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle

Blaser R8 Barrel key (5mm) for the barrel attachment screws the barrel on an R8 Rifle.

• For Glock 26 9MM Finger Extension Floor Base Plate Black
• 1000+ High Resolution Permanent Laser engraved images, will not rub off, not painted, custom engraving too – by NDZ Performance
• 100% Aircraft Grade T6 Billet Aluminum, Mil-spec Hardcoat Anodized Durable Finish
• Replaces Stock Plastic Plate with a Durable Aluminum piece, Easy Install, Requires NO Modifications
• Designed and Made In America, In Our Facility – In NDZ Packaging

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.