GLOCK MEISTER G420 TRIGGER PIN

• Cartridge shell case size: Length is 6″. Width is 1″. Height is 4″.
• Close style ammo cartridge holder is made of quality waterproof nylon. Shooter`s pouch is equipped with 2 rows of elastic loops for 12 or 16 gauge shells and may accommodate up to 12 cartridges.
• This shotgun ammo wallet has two loops at the back to fix it on the belt. Accommodates belts up to 2 1/4 -Inch wide.
• Classic ammo holder for shotgun shells closes with snap buttons to keep your cartridges safe and dry.
• Belt ammo pouch is easy to clean and will keep rounds at hand.

The PG-30 Grip Extension will fit (GEN 1-4) Glock models 30, 30SF, 30S. The Pearce Grip PG-30 Grip Extensions replace the magazine base plate and retains all other factory components. They do not alter the capacity of the magazine. The PG-30 will add additional length forming the next logical finger positioning for better control and comfort without sacrificing conceal ability. These units blend with the contours of the handgun giving a factory appearance.

Blaser R8 Barrel key (5mm) for the barrel attachment screws the barrel on an R8 Rifle.

Super Black Eagle Limited Edition Butt Plate. This black butt plate is constructed from high quality polymer and features a checkered texture and Benelli logo. The butt plate will fit 12 gauge Benelli Super Black Eagle Limited Edition model shotguns.

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

Developed for military use and made from advanced, reinforced polymers, the GPS/Military Model is light enough to preserve weapon balance and deployment, yet still tough enough to withstand hard use, due to its hardened polymer covered stainless steel legs.This is an GPS weapon fore grip with a deployable bipod. When not in use the bipod rests in the body of the grip and is easily deployed with the push of a button. The bipod legs are polymer with metal reinforcements for durability.

Recoil buffers are an easy and inexpensive way to eliminate damage of critical components by preventing the metal to metal contact of the slide or breech block with the frame. Made from a high density polyurethane formulated for maximum shock-absorbing characteristics, the recoil buffer is a drop-in part.The CZ recoil buffer will eliminate the metal to metal impact of the slide on the receiver each time the weapon is fired. You will extend the service life of your pistol as well as have reduced felt recoil by installing one in your weapon. Installation is easy and requires no special tools or modification to your gun.

GLOCK OEM factory Recoil Spring Assembly fits G19, G23, G32, G38 (marked 5593 on end of recoil spring guide). For Generation 1, 2, and 3 pistols.