PICATINNY RAIL FOR RIFLE WITH LOOP

• Fits Vortex Viper/Venom micro red dot sight
• Fits Ade Advanced Optics rd3-001, rd3-02, rd3-009, rd3-006a, fits Sightmark mini shot reflex sight
• Fits Burris Fastfire micro red dot sight(Notes: the screws included in the package are not long enough for some Burris red dot sights, you can use the screws in the red dot)
• Caution: NOT fit RMR, RMS, Doctor.

• For Glock 26 9MM Finger Extension Floor Base Plate Black
• 1000+ High Resolution Permanent Laser engraved images, will not rub off, not painted, custom engraving too – by NDZ Performance
• 100% Aircraft Grade T6 Billet Aluminum, Mil-spec Hardcoat Anodized Durable Finish
• Replaces Stock Plastic Plate with a Durable Aluminum piece, Easy Install, Requires NO Modifications
• Designed and Made In America, In Our Facility – In NDZ Packaging

Blaser R8 Barrel key (5mm) for the barrel attachment screws the barrel on an R8 Rifle.

This item features: -Specially formulated paint in stick form designed to color-brighten stamped or engraved lines and lettering. -Paint stays flexible, expands and contracts with the surface. -Contains no solvents. -Long-lasting will not rub off or smear. -No mess or waste, eliminates dripping brushes and paint spills. -Temp. Range: -50.0 F [Min], 150.0 F [Max]. -Applicable Materials: Metal, Plastic, Ceramics, Wood, Rubber, Glass. Meets U.S.A. federal specification TT-F-325a I and MIL-STD 171.

Blaser sling swivel loop and pivot pin/screw.

Fits all Blaser rifles with fixed studs and will suit straps of up to 20mm x 3.5mm

Vibra-Tite 111 is a low strength, anaerobic thread locking compound. Vibra-Tite 111 is design for locking threaded fasteners that require disassembly with standard hand tools. The product performs on aluminum, steel, plated, stainless steel, and special alloy parts. Vibra-Tite 111 exhibits good temperature and solvent resistant.

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle