BUSH HANGER BAR #NH1297-X-BAR

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

Hogue rubber grips are molded from a durable synthetic rubber that is not spongy or tacky, but gives that soft recoil absorbing feel, without effecting accuracy. This modern rubber requires a completely different molding process than ordinary neoprene and results in a much superior grip. The material used does not come apart or deteriorate and is resistant to all solvents and oils used around firearms.

• Cartridge shell case size: Length is 6″. Width is 1″. Height is 4″.
• Close style ammo cartridge holder is made of quality waterproof nylon. Shooter`s pouch is equipped with 2 rows of elastic loops for 12 or 16 gauge shells and may accommodate up to 12 cartridges.
• This shotgun ammo wallet has two loops at the back to fix it on the belt. Accommodates belts up to 2 1/4 -Inch wide.
• Classic ammo holder for shotgun shells closes with snap buttons to keep your cartridges safe and dry.
• Belt ammo pouch is easy to clean and will keep rounds at hand.

This item features: -Specially formulated paint in stick form designed to color-brighten stamped or engraved lines and lettering. -Paint stays flexible, expands and contracts with the surface. -Contains no solvents. -Long-lasting will not rub off or smear. -No mess or waste, eliminates dripping brushes and paint spills. -Temp. Range: -50.0 F [Min], 150.0 F [Max]. -Applicable Materials: Metal, Plastic, Ceramics, Wood, Rubber, Glass. Meets U.S.A. federal specification TT-F-325a I and MIL-STD 171.

Blaser R8 Barrel key (5mm) for the barrel attachment screws the barrel on an R8 Rifle.

• For Glock 26 9MM Finger Extension Floor Base Plate Black
• 1000+ High Resolution Permanent Laser engraved images, will not rub off, not painted, custom engraving too – by NDZ Performance
• 100% Aircraft Grade T6 Billet Aluminum, Mil-spec Hardcoat Anodized Durable Finish
• Replaces Stock Plastic Plate with a Durable Aluminum piece, Easy Install, Requires NO Modifications
• Designed and Made In America, In Our Facility – In NDZ Packaging

The PG-30 Grip Extension will fit (GEN 1-4) Glock models 30, 30SF, 30S. The Pearce Grip PG-30 Grip Extensions replace the magazine base plate and retains all other factory components. They do not alter the capacity of the magazine. The PG-30 will add additional length forming the next logical finger positioning for better control and comfort without sacrificing conceal ability. These units blend with the contours of the handgun giving a factory appearance.

• HOGUE Rubber GRIP 20000
• fits SIG Sauer P220 American Rubber W/ Finger Grooves
• Rubber Grips
• P220 American