PISTOL BARREL 22LR

GLOCK OEM factory Recoil Spring Assembly fits G19, G23, G32, G38 (marked 5593 on end of recoil spring guide). For Generation 1, 2, and 3 pistols.

• Fits Vortex Viper/Venom micro red dot sight
• Fits Ade Advanced Optics rd3-001, rd3-02, rd3-009, rd3-006a, fits Sightmark mini shot reflex sight
• Fits Burris Fastfire micro red dot sight(Notes: the screws included in the package are not long enough for some Burris red dot sights, you can use the screws in the red dot)
• Caution: NOT fit RMR, RMS, Doctor.

Vibra-Tite 111 is a low strength, anaerobic thread locking compound. Vibra-Tite 111 is design for locking threaded fasteners that require disassembly with standard hand tools. The product performs on aluminum, steel, plated, stainless steel, and special alloy parts. Vibra-Tite 111 exhibits good temperature and solvent resistant.

Blaser sling swivel loop and pivot pin/screw.

Fits all Blaser rifles with fixed studs and will suit straps of up to 20mm x 3.5mm

The PG-30 Grip Extension will fit (GEN 1-4) Glock models 30, 30SF, 30S. The Pearce Grip PG-30 Grip Extensions replace the magazine base plate and retains all other factory components. They do not alter the capacity of the magazine. The PG-30 will add additional length forming the next logical finger positioning for better control and comfort without sacrificing conceal ability. These units blend with the contours of the handgun giving a factory appearance.

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

Hogue rubber grips are molded from a durable synthetic rubber that is not spongy or tacky, but gives that soft recoil absorbing feel, without effecting accuracy. This modern rubber requires a completely different molding process than ordinary neoprene and results in a much superior grip. The material used does not come apart or deteriorate and is resistant to all solvents and oils used around firearms.

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle