REM 870 PISTOL GRIP

• Fits Vortex Viper/Venom micro red dot sight
• Fits Ade Advanced Optics rd3-001, rd3-02, rd3-009, rd3-006a, fits Sightmark mini shot reflex sight
• Fits Burris Fastfire micro red dot sight(Notes: the screws included in the package are not long enough for some Burris red dot sights, you can use the screws in the red dot)
• Caution: NOT fit RMR, RMS, Doctor.

• 48.5″ x 156.5″ x 10″
• Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur
• Fits 9mm, 357SIG or .40 cal guns
• Will NOT fit the Allround models and the 226 Legion
• Manufactured from a soft durable rubber and features a lightweight, synthetic skeleton insert that makes up the rigid interior of the handle

Blaser sling swivel loop and pivot pin/screw.

Fits all Blaser rifles with fixed studs and will suit straps of up to 20mm x 3.5mm

GLOCK OEM factory Recoil Spring Assembly fits G19, G23, G32, G38 (marked 5593 on end of recoil spring guide). For Generation 1, 2, and 3 pistols.

• For Glock 26 9MM Finger Extension Floor Base Plate Black
• 1000+ High Resolution Permanent Laser engraved images, will not rub off, not painted, custom engraving too – by NDZ Performance
• 100% Aircraft Grade T6 Billet Aluminum, Mil-spec Hardcoat Anodized Durable Finish
• Replaces Stock Plastic Plate with a Durable Aluminum piece, Easy Install, Requires NO Modifications
• Designed and Made In America, In Our Facility – In NDZ Packaging

The Choate Flash Hider and Front Sight for the Ruger Mini-14 fits most 580 and higher series rifles. For use on rifles with a barrel diameter of 0.625″, make sure to measure the barrel before you order, some of the early 580 series rifles have the smaller 0.562″ barrel. The compensator is attached to the gun barrel by a 1/8 inch spring steel roll pin. Gunsmith installation recommended to drill hole for roll pin.

Blaser R8 Barrel key (5mm) for the barrel attachment screws the barrel on an R8 Rifle.

Developed for military use and made from advanced, reinforced polymers, the GPS/Military Model is light enough to preserve weapon balance and deployment, yet still tough enough to withstand hard use, due to its hardened polymer covered stainless steel legs.This is an GPS weapon fore grip with a deployable bipod. When not in use the bipod rests in the body of the grip and is easily deployed with the push of a button. The bipod legs are polymer with metal reinforcements for durability.

Hogue rubber grips are molded from a durable synthetic rubber that is not spongy or tacky, but gives that soft recoil absorbing feel, without effecting accuracy. This modern rubber requires a completely different molding process than ordinary neoprene and results in a much superior grip. The material used does not come apart or deteriorate and is resistant to all solvents and oils used around firearms.